Name |
Description |
|---|---|
Copper Balancing |
This attribute is attached to features which are added during a pattern fill operation, either manually or through the Copper Balance DFM action. If a line or arc has this attribute attached, then it will not be reported in the line histogram display. |
Copper Feature Ignore |
Copper features bearing this attribute are ignored in analysis actions. (Presently implemented only for Rout Test.) |
Copper Text |
This attribute defines a feature as a nomenclature legend feature. The attribute affects the fabrication analysis by directing spacing checks between such features into a new category (Text to text). |
Drill Type |
This attribute is attached to hole features in drill layers. It defines the type of drill and is used extensively during fabrication analysis. |
Pad Usage |
The feature attribute Pad Usage is attached to pads on outer signal layers. It value can be one of the following: toeprint via g_fiducial l_fiducial tooling_hole |
SMD Pad |
This feature attribute should be attached to outer layer pads which are lands for SMD components. It is set by the ‘Set SMD Attribute’ Cleanup Action. |
Name |
Description |
|---|---|
Ignore Graphically/Output |
This attribute is attached to a component to be ignored during DFM actions. |
Required Toeprint Spacing |
This attribute is specifically attached to components for reporting in the Toeprint to Toeprint category. It defines the maximum spacing within which to report pad to pad spacing measurements. Range: 1-500 Units: inch or mm |